Hazardous area classification, explained
Zones, divisions, gas groups and temperature classes decide which equipment may sit in a classified area. IP and NEMA ratings answer a different question.
Process Variable (PV)
Measured value in a control loop.
Live measurement fed back to the controller: the transmitter reading the loop compares against its setpoint. PV quality (range checks, freeze detection) decides whether automatic control is safe.
See also: PID loop · Setpoint (SP)
Use the concept: 4–20 mA loop scaling · Process instrumentation: signal, measurement and control · Compressed air leak cost calculator
In depth
PLC FAT and SAT checklist: test behavior and handover evidence
Plan factory and site acceptance around requirements, observable results, failure states, approved changes and recoverable project files.
PLC analog input scaling: raw counts, 4–20 mA and diagnostics
Map raw counts into engineering units, check the configured channel range, and keep signal-quality diagnostics separate from the displayed value.